How to Use a Torque Meter Wrench? Find out Here!

Not every part of your automotive vehicle or motor based machine requires torque measurement but some of them require it badly. It’s all about the suspension, engineering, and drive-train of the part which will decide how long the machine can bear. That’s why regular torque measurement keeps the motor running. But how exactly can you use a torque meter wrench to find out the torque? This question can be answered below.

So let’s check it out!

1.     Wrench Types

You can find numerous types of a torque wrench – hydraulic, slipper, electronic, deflecting beam, click and mechatronic wrench. You have to figure out which one will go with your machine or automobile. The commonly used wrench is the click and hydraulic. You can go any of these wrenches.

2.     How to use it?

Using a torque wrench is easy as long as you follow the right steps. There are some basic principles you can consider while counting the torque through the wrench.

ü  Don’t use a wrench as a breaker bar. It will completely damage and destroy the calibration.

ü  Always place the wrench at the required spec and stop after a beep or click. But make sure that you are not over-torquing the fastener.

ü  Don’t take apart the wrench ever.

   You can calculate two types of torques with the torque wrench and that are rotational and clamping torque. These types might seem similar but are different in many perspectives. The final torque rating applied to a fastener can be counted as the clamping torque whereas, the force required initiating the movement is called the rotational torque.

You can calculate the clamping torque with any regular wrench. On the other hand, rotational torque demands an electronic torque or a rotational beam. That’s because you have to keep an eye on the dial to get accurate readings.

The rotational torque needs to be settled at a pinion preload. It measures inch/pound. A beam wrench is considered to be the perfect for this torque as it can focus on the beam easily.

NOTE: The modern vehicles are using torque-to-yield fastener that usually needs to be replaced. This means you cannot reuse the fastener. Therefore, it involves a special procedure to get the specific measurements and then tightening to a supplementary amount. It’s vital to know what you are dealing with so that you can attain the objective to get an accurate torque reading with a torque wrench.

Wrapping Up

Now that you know what can make your machine efficient and durable, it’s time to get your reaction torque sensor from a trusted place. So go online and buy one of the best torque wrenches so that you can measure only the perfect torque.